The Factors of a Water Heater Tank Explosion

Posted by on Jan 22, 2015 in Gas Water Heater Repair Las Vegas, Water Heater Repair Las Vegas, Water Heater Safety

In terms of needing to undertake upkeep on ones water heater, it is a relatively minimal maintenance device.  Even so, one important component of it ought to be examined routinely.  Water Heater Repair Las Vegas wishes to pass on this safety material concerning ones water heater today.Water Heater Repair Las Vegas

High temperature if coupled with tank deterioration inside of the storage tank can result in an explosion. Whenever the water temperature is under 212 degrees Fahrenheit, one shall be protected from an explosion, though there is a associated risk of scalding at that temperature.  However, if the water temperature is more than 212 degrees, water transforms into steam, which will enlarge to 1,700 times the space it takes up as water. This is the time an explosion can take place.

Cautionary Indicators of a Water Heater Explosion

The leading sign is if one goes to get hot water from a faucet and only steam comes out.  Quickly shut off electric power if one possesses an electric water heater.  If one possesses a gas hot water heater, shut off the gas valve on the water heater.  After that, give us a call to come pinpoint the predicament.

Minimizing Potential Water Heater Dangers

The most significant routine maintenance job having a water heater is to examine the pressure relief valve, referred to as the T&P valve, on a usual schedule.   This valve helps control the pressure accumulation within the water storage tank to avoid a hazardous increase in temperature and overpressure.

Caution!
Take note, the water release coming from a T&P valve might be really hot. If you do not feel safe evaluating the valve contact us.  In addition, performing any kind of fixes to the valve ought to be completed by a experienced plumbing repair provider.

How to Test the T&P Valve

Clear the spot near the overflow pipe and floor drain.
Lift up the test handle for roughly 5 seconds or until the water runs clean.
Let go of the handle.
If the T&P valve keeps on running with water, raise the handle up and down rapidly to have it reseat itself.  One may need to do this a couple of times.  IF it has not been tested for a while, it might be difficult to raise it at first.  Avoid using a lot of force, although could need to make use of just a little.
If the T&P valve continues to have water coming out, it ought to be changed.

Additional points to watch out for are rust on the stem of the valve.  If there is any water seeping out of the valve stem or out of the drain valve.

Searching for far more suggestions?  Take a look at Water Heater Repair Las Vegas’s additional articles right here:

Upcoming Changes to Water Heater Regulations

Las Vegas Water Heating Savings Advice

From around the Web:

The Aquanta smart water-heater controller promises to slash your energy bill

Home maintenance checklist: Fall