Blog

Water Heater Repair Las Vegas Blog

Our blog is designed to give homeowners as much information on general plumbing repair tips, not just Las Vegas water heater repair advice.  Many home plumbing maintenance tasks homeowners can be well equipped  to take care of themselves.  Enjoy!

Las Vegas Water Heating Savings Advice

Posted by on Nov 7, 2014 in Water Heater Repair Las Vegas, Water Heating Savings | 0 comments

Faucet aerators and low flow shower heads help to conserve water, and water preservation implies home energy cost savings for you.

Bathroom and kitchen faucet aerators are simple to add to ones faucets. The wire screens just screw in and will mix air into the water flow, in a sense, rationing the water flowing out of the faucet.Water Heater Repair Las Vegas

When first introduced the initial purpose was to simply lower the flow rate or water stream in order to remove sink splashing.

However, with the increasing interest in water preservation, house owners and businesses that are looking to conserve on energy usage, are ending up being more interested in the water saving capacity of faucet aerators.

In terms of ones Las Vegas water heater, aerators do not simply save water, they likewise help in reducing the natural gas and electricity cost involved with water heating. Aerators combined with water saving shower heads can decrease the typical houses hot water usage by as much as 50 percent.

Both water saving devices are exceptionally low-cost and really easy for homeowners to set up.

Low flow aerators can be added to practically any basic faucet. Look along the tips of ones faucets to see if there are threads along the inside. Even numerous older restroom and kitchen sink faucets are pre-threaded.

If one currently has older aerators installed, they can be removed by hand or with a wrench. The flow rate (which is determined in gallons per minute or gpm) is probably imprinted along the side. Newer faucet aerators can substantially decreased flow rates even further than older models and all without lowering the water pressure.

Kitchen Sink Aerators

Kitchen faucets normally demand greater flow rates than a restroom faucet. Because of this, aerators with minimum flow rate of 1.5 gpm is highly advised for saving water. However kitchen sink faucets without aerators can make use of as much as 3 to 5 gallons of water per minute.

A new model of aerators have swivel pivots that permit a circular or rotating motion which is helpful when cleaning ones kitchen sink. Those who wash dishes by hand may find a swivel aerator with a shut off valve even more perfect.

Bathroom Aerators

Bathroom aerators normally are chrome plated or brass. They provide a more direct and pressurized spray than the majority of kitchen aerators. And bathroom aerators normally cost even less, varying anywhere from $2 to $5 each.

Bathroom faucets without these accessories can use anywhere from 2 to 4 gallons of water per minute. New low flow restroom aerators utilize as little as 1 to.5 gallons per minute and all without lowering water pressure.

Remember to Keep Aerators Clean

The wire screens can get clogged with sediments and other mineral deposits after months or years of consistent use. Periodically remove for a cleaning. This will certainly solve potential water pressure troubles along with avoid future faucet leakages.

Low Flow Shower Heads

Installing low flow shower heads is truly among the most cost effective things any property owner can do to save water. 30 % to 40 % of American houses today have traditional bathroom shower heads installed which make use of as much as 5 to 7 gallons of water per minute.

The low flow shower heads currently on the market are not the old flow restricting designs of the past. A new water conserving shower head can considerably decrease ones water make use of and increase water pressure at the same time.

Now water saver shower heads make use of air chambers or jet streams to quickly mix air into the water flow. The streams and chambers permit the shower heads to use considerably less water, as well as increase water pressure for that unwinding massage sensation.

Recently some models have actually effectively reduced water flow rates even lower than the federal guidelines. Some low flow designs use as low as 1 gallon of water per minute.

A few of the best shower heads permit one to stop briefly warm water while in the shower. These shower heads are exceptionally convenient and they can assist one conserve much more by using less warm and hot water while bathing.

This provides ones hot water heater a much needed break, which in return equates into lower water heating expense.

Check out Water Heater Repair Las Vegas’s other tips in our blog here too!

Las Vegas Water Heater Installation Costs

Posted by on Nov 6, 2014 in Water Heater Replacement Las Vegas | 0 comments

The average life-span of a standard tank-style natural gas water heater or electric water heater is around eight to 12 years, so the prospect of needing to change a water heater is a typical home improvement. Water Heater Repair Las Vegas has written some of the factors that affect the setup costs below.

The expenses to set up a new Las Vegas hot water heater do vary in cost depending upon the business performing the installation, and relying on the kind of water heater installed. As an example, energy-efficient tankless water heaters do cost more to install, though those expenses can be regained over the life of the unit.

Water Heater Installation Cost Factors

Without seeing the location that ones water heater will be installed or replaced, it is hard to offer a certain idea of the expense. If it is a water heater replacement, and is being replaced with a similar sized and design of heater, the setup costs will be very reasonable. If one is changing to a different type of water heater, like from an electric to a gas or tankless device, the installation expenses will certainly be higher due to the fact that we will need to possibly add gas lines and hookups.

Another factor to consider is to ensure a replacement water heater will be up to code with exactly what is needed now, not with what the code was ten to 12 years earlier when the current water heater was installed. Likewise, there is the potential that the existing water heater was not up to code when it was initially installed either! Which can be the case if a previous house owner did the installation him or herself.

Because of the safety elements involved with water heating systems, it is always best to have an expert plumbing business take care of the setup. One, most homeowners will not have an idea of exactly what the code standards are. One threat aspect is that electric water heaters use 240 volts of electrical power, which is very harmful to work with if not experienced in doing this. Water Heater Repair Las Vegas NV spends a lot of time repairing poorly set up water heaters.

Another safety concern with not having a professional set up ones water heater is dealing with gas lines. This, too, can be hazardous, and a situation where there can not be any leakages.

A final safety concern is with effectively venting the exhaust to make sure carbon monoxide gas escapes out of the house. Carbon monoxide gas poisoning occurs more often than the majority of people believe, and it is best to ensure one has a carbon monoxide gas detector in ones house too. According to the Centers for Disease Control, unintentional carbon monoxide poisoning triggers 400 deaths each year and 20,000 visits to the emergency room.

Other factors to consider with setting up is ensuring it is plumbed correctly, there is enough clearance and ensuring drip pans are geared up, if needed.

How to Flush a Las Vegas Water Heater

Posted by on Jan 17, 2014 in Water Heater Repair Las Vegas | 0 comments

Ok, so it is not an attractive water heater upkeep task, but it does require a little cleaning up from time to time. Yes, today Water Heater Repair Las Vegas is going to advise one on the best ways to flush out a water heater. Some suggest doing this as soon as every one to 3 years, we feel it is best to do so as soon as a year. Doing so is not a hard or time consuming project – heck, let the children assist even.

Why Flush a Las Vegas Water Heater?

If it is last the suggested life span of the system, it should have some kind of routine flushing done. Doing so will obviously aide in having it run as efficiently as possible, which also indicates conserving money on the cost of running the darn thing. That alone ought to be a sufficient reason we feel!

In terms of water heater upkeep, flushing it will get free of the buildup of mineral deposits that natural takes place inside the water storage tank. If one has actually ever had loud sounds, popping, gurgling, mini-explosion noises, that is an indicator that there is too much sediment inside the tank. This flushing process will help make sure that the tank heats up water much more quietly.

Step 1. If it is an electric water heater, turn the power off in the primary electric breaker box and turn the cold water supply off. If it is a gas heater, it is ok to leave the gas on – simply turn the water off. Though, turn the thermostat setting dial to the pilot setting (make a note to bear in mind what it was initially set at though for later). Then, whichever faucet the water heater supplies is closest has to be opened. This is generally simpler than opening the pressure relief valve, however one can do that instead.Water Heater Repair Las Vegas

Step 2. At the bottom of the water heater is a drain valve that a garden watering hose can be connected to. There might be a cover over it depending on the manufacturer. Think about turning the heat to the pilot setting a number of hours before flushing it if one desires so the water isn’t really going to be as hot when it is drained. If that is not an alternative that’s fine, simply see to it the garden hose made use of is in good condition to withstand the greater temperature water.

Run the hose outside far from the residence or if the water has cooled, one can drain the tank into buckets.

Step 3. Open the water heater’s drain valve and start draining the water. For whatever reason the drain valve is generally made of plastic, so if one has an older water heater (and one that has actually not been drained since before time started) it might stick a little. Just beware to not break the plastic (which is why it would be nice if the darn thing was NOT made of plastic).Water Heater Repair Las Vegas AZ

When the drain valve is open, likewise open the pressure relief valve on the heater. Water will (at least it must if it pressure relief valve is working appropriately) flow some from it. Try to let is stream stable and not too quickly so it stirs up the sediment in the water heater. We want the sediment to drain out the bottom from the hose.

If draining in a container, even if having the hose drain into a container outside of the garage or basement where the water heater is located, fill a container and let it sit to see if the water is clear or if there is sediment, which will normally appear like sand in the bottom of the container. Just keep draining it till the water is clear.

Step 4. Close the drain on the bottom of the tank and close the pressure relief valve if it is still open.

Step 5. Turn the water supply on once more to fill the tank. When it is full again, slowing open the pressure relief valve again to get some excess air out of the tank. Then, open a hot water faucet in your home to get even more air out of the system.

Step 6. Let the hot water in the bathtub run till a complete stream is flowing out. Once that occurs, it is ok to turn the power back on if it is an electric water heater, or reset the temperature level setting for a gas water heater. Obviously, turn the bathtub faucet off. In about 20 minutes, the hot water should be heated up once more.

There you go! Water Heater Repair Las Vegas NV is here to address any questions you could have. Next take a look at our short article on what to do if one has no hot water.

Troubleshooting No Hot Water from a Water Heater

Posted by on Jan 15, 2014 in Water Heater Repair Las Vegas | 0 comments

Let us break down the conversation on why one may not have any hot water from the water heater into two different parts: having NO hot water and having LIMITED hot water.

No Hot WaterGas Water Heater Repair Las Vegas NV

In regards to having no hot water at all, Water Heater Repair Las Vegas suggests that it is most likely since of one of the following four various possibilities (at least it is probably just one). Below they are …

A Bad Pilot Light
Hopefully this holds true because it is the easiest of the 5 to fix. Initially check to see that it is still lit. One may should have a look at the owners manual (sorry men, however sometimes we require to read directions) if you are having a difficult time finding where it is located. Manufacturers due tend to hide them nowadays it seems. And, to see what the makers directions are for relighting the pilot light.

Gas Line Leak
If one has a gas water heater, there could be a leakage in the line. If one has an electric one, undoubtedly disregard this as a possibility. Some people have a difficult time smelling gas, though my mom has a remarkable capability to smell it I vividly remember as a kid. It most likely will have the smell of rotten eggs. If this holds true, all jokes aside, turn the gas line off if one knows where it is and call the gas company and/or a plumbing company if one does not reside in Hot Water Heater Repair Las Vegas’s service area. This is a serious issue that requires immediate attention!

A Bad Thermostat
This might be the concern for both not having any hot water, or just not having enough hot water. To be on the safe side we included it in this section though. See to it the thermostat dial settings have not been bummed or changed by accident. Our water heater is found in the garage and the happy fingers of twin children like to go exploring now and then. If the
settings are exactly what they usually are, turn the establishing some and see if it does the technique. The thermostat can be replaced for they do wearoccasionally.

A Bad Thermocouple
For gas water heaters, the thermocouple works in hand with the pilot light as a safety device. If the pilot light is out, it avoids gas from being switched on, so it is sort of important. Nevertheless, easy to change if required. When the thermocouple begins to break, it “informs” the gas valve that the pilot is out so it turns off the gas. The burner will not light then and the pilot light goes out.

For electric water heaters, it makes use of a heating element inside to conduct the electrical current heating the water. These can likewise wear out and will result in decreased hot water.

Not Enough Hot Water

Sediment Buildup
If one is not in the routine of flushing the water heater tank periodically, like a minimum of once every couple years, sediment from the water will buildup in the bottom of the tank. If one ever hears popping or banging noises from the tank, that is most likely why. This will ultimately minimize the heaters capability to make sufficient hot water. Routine flushing will typically solve this problem. If the water in the house is excessively hard, making use of a water softener will help combat an excess amount of sediment buildup too.

Other Possibilities
There may be a problem with the flame from the burner. Please make sure the area around and below the water heater remains clean from dirt. The water heater pulls air up from below for the burner. Natural gas flames will burn bright blue with a yellow tip, while propane are more bluish green on the body of the flame.

It might be the case that the tank size is just too small and not able to manage the water heating needs, however obviously if it is a new issue of not enough hot water and ones usage level has actually not considerably increased, this will not be the case.

If any recent repairs were made on the system something might be crossed in terms of the electrical connections or the cold and hot water connects, however once again, pretty unlikely from most plumbing companies.

There are various other possible causes, however for the sake of time below, Water Heater Repair Las Vegas NV just desired to share the most probably ones. Do not hesitate to let us know of any support required!

Water Heater Repair Las Vegas Video Overview

Posted by on Jan 5, 2014 in Plumbing Repair Las Vegas, Water Heater Repair Las Vegas | 0 comments

Water Heater Repair Las Vegas has made a new company video summary and we wanted to share it with you today. Do not hesitate to contact us for any plumbing repairs and replacements that you may have to have performed at work or at home.